A concrete cold joint is where fresh concrete meets already hardened concrete after a delay. Expansion joints help control movement and prevent cracking by giving concrete room to expand and contract. This discontinuity occurs because the older material has passed its initial setting time, preventing a true chemical bond with the fresh mix. While most are deliberate and strengthen the structure, one, in particular, does not: the cold joint.
Read More
In this guide, we'll walk you through the entire process of preparing fiber optic cable for splicing and termination to fiber connectors. Active connection utilizes various fiber optic connectors (plugs and sockets) to connect site-to-site or site-to-cable. This method is flexible, simple, convenient, and reliable, commonly used in building computer network cabling.
Read More
These variables can be broken into two groups: intrinsic factors and extrinsic factors. An important thing to note and keep in mind is that optical fibers are not perfect, and variations between optical fibers can. There are two primary techniques for terminating fiber optic cables: Splicing: Joining two fiber optic cables permanently. Optical fiber transmission has the advantages of wide transmission frequency, large communication capacity, low loss, no electromagnetic interference, small diameter of optical cable, light weight, rich source of raw materials, etc. Fiber optic strands are ultra-lightweight and about as thin as human hair, and yet, they have more than eight times the pulling tension of a copper wire.
Read More
Cold welding can ensure fast and strong joins in wires and is commonly used with aluminium, 70/30 brass, copper, gold, nickel, silver, silver alloys, and zinc.
Read More
How do you need to design control circuit wires to comply with UL 508A? The wire size for control cables within the control panel must be a minimum of 18 AWG, with the exception of control cables for PLC inputs/outputs. Electrical control panel wiring should be organized well or it can be unsafe or even hazardous. Much of the requirements have to do with control circuit conductor protection, against both overcurrent and short circuit, and the type of wires used inside and outside of a control enclosure. This article summarizes what this author believes are some best practice when it comes to control panel layout and wiring.
Read More+34 910 257 483
Calle de la Innovación 22, 28043 Madrid, Spain