For LOS (Loss of Signal) red lights on fiber or advanced gateways, it usually means the incoming optical line is not detected or has low signal. Double-check that the fiber line is connected properly and that there's no bend or physical damage. However, when it blinks red or stays solid red, it signifies a Loss of Signal, a problem preventing your router from communicating.
Read More
Use a robust insulation resistance tester to check whether light switches are connected correctly. Many people automatically shy away from electrical work and it can be dangerous, so it's worth hiring a professional electrician to do this for you. There are three ways to perform switch tests without a multimeter that I will discuss. These indicators will help you tell if a light switch is bad and needs repair or replacement: If the light flickers, test the bulb in another fixture.
Read More
This tells you how much light is making it through the fiber cable to your switch. If the value crosses these numbers, the switch logs a syslog message or shuts down the port. If either Tx or Rx is in the -30 dBm or lower range that's usually indicative of there being no actual signal received and the transceiver is reporting. The switch reads all values like RX/TX high/low warning and alarm thresholds from the. Does anyone have a solid rule of thumb or a cheat sheet for quickly looking at a dB reading on an optic within a router/switch/firewall/etc and being able to interpret it as acceptable or not? Does the threshold change for SMF and MM vs 10g and 1g, etc? Just trying to get a few tips from people.
Read More
Screen brightness can be adjusted only while in handheld mode or tabletop mode. Enable/disable automatic brightness, or manually adjust the screen brightness by. The only thing that I know to try is to go into maintenance mode and initialize the console while keeping save data to see if it's just a software bug that can be reset. How can one go about diagnosing the exact issue with the switch? I want to increase my skills in fixing electronics, so any advice? Is this a good question? Hi @eduardobau50221 Do you have a DMM (digital multimeter) and know how to use it? If so then the first thing to do when you have a device.
Read More
Connect any of the "LAN" ports on the first router to a port in the switch. TL;DR: Is there a way to have two different (unreliable) ISPs connected to a single network switch, so that when one drops out, the home network is automatically switched to the other ISP? --- Hi all! I am a networking hobbyist, and I built out a home network for a family friend of mine living in. In computer communications, a Local Area Network (LAN) can have multiple connections to external Internet Service Providers. This is typically done for fault tolerance--if one link falls, the LAN is still connected to the outside world through the other link--and for increased bandwidth.
Read More+34 910 257 483
Calle de la Innovación 22, 28043 Madrid, Spain