SINGLE AND DOUBLE DOCKING STATIONS SAFECONNECT

Overlapping position of double armored optical cable

The armoring is placed either just under the outside plastic jacket for single jacket cables or between two layers of jacket material for dual jacket cables. Where reels are supplied with protective material fitted over the cable, the protection should remain in place until the cable will be installed. The following formula may be used to determine general guidelines for installing LSZH steel armor fiber optic cable: At the completion of a day's installation, protect bare cable ends by placing a cable cap on the end of the cable, followed by several wraps of tape around each cap. The cable is intended for use in areas where moderate to high protection is required (typically system shore ends). This guide provides a complete installation process for armored fiber optic cords, explaining each step from routing and pulling to stripping, cleaning, and testing.

Double cone distribution box

Plastic case, self-extinguishing polycarbonate envelope for low voltage distribution or small automations. Smooth sides and pre-cut inputs, protection grade IP-54, halogen-free, opaque screw-locking cover. Among our distribution boxes you will find the smart and practical solution for your project or business.

Roof cable trays for photovoltaic power stations

Solar Cable Tray is a specialized support system designed to safely route, organize, and protect electrical cables (DC strings, AC output, communications) on rooftops with solar photovoltaic (PV) installations. Providing cable support, cable protection, and wire management, Our solar cable tray systems and solar cable support systems are engineered for utility solar mounting applications. Cable trays in photovoltaic (PV) industry are essential components for the proper management, protection, and support of electrical cables in PV power plants. Made from high-quality galvanized steel or aluminum, it offers superior durability, corrosion resistance, and ventilation to prevent overheating.

In double busbar wiring

Double busbar wiring is a substation configuration where two busbars (conductive bars that serve as common connection points for multiple circuits) are used to distribute electrical power. Here, we provide an overview of common substation busbar configurations—Single Bus, Main and Transfer, Double Breaker/Double Bus, Ring Bus/Ring Main, and Breaker and a Half. Designing a substation involves not only the visible equipment and ratings but also the less apparent factors—operational. In double bus bar system two identical bus bars are used in such a way that any outgoing or incoming feeder can be taken from any of the bus. Actually every feeder is connected to both of the buses in parallel through individual isolator as shown in the figure. These setups are designed to enhance system reliability, flexibility, and fault tolerance.

IK10 Temperature-Controlled Cabinet for Base Stations

These advanced enclosures deliver reliable protection for critical electrical and communication equipment in outdoor heavy-duty settings. Protection: IP66 IK10 (Non-ventilated); IP55 IK10 (Ventilated) Standards (& Conformities): IEC/EN 60529, IEC/EN 62208, EIA-310-D, RoHS . The IK (Impact Protection) rating system, defined by IEC 62262, provides a standard-ized method to evaluate the robustness of electrical enclosures against mechanical impacts. METALLIC ENCLOSURES IP65 IK10 We manufacture different types of metallic enclosures are available such as floor-based cabinet type enclosures, wall-mounted or built-in placement, power transfer enclosures (low and medium voltage) and floor-based or wall-mounted pillar-type enclosures.

SINGLE AND DOUBLE DOCKING STATIONS SAFECONNECT

Overlapping position of double armored optical cable

Double cone distribution box

Roof cable trays for photovoltaic power stations

In double busbar wiring

IK10 Temperature-Controlled Cabinet for Base Stations

Get In Touch

Connect With Us

Email

Spain (Sales & Engineering HQ)

Headquarters & Manufacturing