The MF47 internal magnetic pointer multimeter is a high-precision analog instrument designed for reliable measurements. MULTIRANGE: With the multi-range measuring range, the button has a strong pause feeling and there are no gaps in the gaps so you can use it with confidence. It can be used for side current DC current, AC and DC voltage, DC resistance, etc.
Read More
In this episode #0018 of Electronic Components Testing, we reveal how to test an optocoupler (optoisolator) using a digital multimeter step by step. Optocouplers, also known as optoisolators, are essential components in countless electronic circuits. Their ability to provide electrical isolation between two circuits while maintaining data transfer is crucial for safety and preventing ground loops. This comprehensive guide will walk you through the process of using a multimeter to diagnose and troubleshoot optocouplers, including troubleshooting common issues and providing insights into their practical applications. An opto-isolator contains a source (emitter) of light, almost always a near infrared light-emitting diode (LED), that converts electrical input signal into light, a closed optical channel (also called dielectrical channel, and a photo sensor, which detects incoming light and either generates.
Read More
The steps for operating a relay protection tester can be divided into the following stages: ✅ Preparation: ⇨Make sure the tester is connected to a 220V AC power supply and is reliably grounded. ⇨Start the tester, select "I accept" and confirm, and wait for the system to. Hope that the technical data and help information in the manual will be provided to you as detailed as possible about how to use Kingsine products.
Read More
A diffractive beam splitter can generate either a 1-dimensional beam array (1xN) or a 2-dimensional beam matrix (MxN), depending on the diffractive pattern on the element. In its most common form, a cube, a beam splitter is made from two triangular glass which are glued together at their base using polyester,, or urethane-based adhesives.
Read More
You use a fiber microscope or automated inspection scope to check for contamination, pits, chips, cracks, and scratches. For structured and repeatable assessment, you follow the criteria defined in IEC 61300-3-35 and the geometry requirements from IEC 61755 for PC and APC. One can verify that a fiber endface is clean, undamaged and overall within quality limits, e.
Read More+34 910 257 483
Calle de la Innovación 22, 28043 Madrid, Spain