Has your electrical socket cracked its casing or mysteriously stopped functioning? As long as it's a standard home outlet, the repair is pretty achievable even if you're not a DIY expert.
Read More
All assemblies on construction and demolition sites for the distribution of electricity shall be in compliance with the requirements of BS EN 61439-4. However, exposure to weather, frequent relocation, rough use and other condi-tions not normally encountered with conventional wiring systems necessitate special consideration not require in other applications or in completed structures. We test all of our CEE plugs and sockets according to the following standards before shipping them: The international standard IEC 60309 applies to plugs, receptacles, connectors and appliance couplers that are mainly used in industrial sectors (rated voltage up to 1. This fact sheet explains how to apply the requirements shown in AS/NZS 3012:2019 Electrical installations – construction and demolition sites (AS/NZS 3012:2019), which is called up as a mandatory standard by section 163 of the Work Health and Safety Regulation 2025 (WHS Regulation). Standard procedures for lighting and socket installation provide safety, efficiency, and adherence to electrical codes.
Read More
What Is a Distribution Box?A distribution box, also known as a power distribution unit, is a critical component in any electrical system.
Read More
Learn what OSHA requires for temporary wiring on construction sites, from grounding and GFCI protection to overhead clearances and employer liability. The recommended procedures in this data sheet are intended to eliminate the unsafe. This Guide designates the practices that should be followed by the member firms of the Infrastructure Health & Safety Association (IHSA) when involved in de-energizing isolated electrical circuits or apparatus. As federal and local regulations regarding jobsite safety evolve and become stricter, it's vital to understand the best way to set up and maintain compliant temporary power systems.
Read More
NEC Article 314: Defines installation requirements for outlet boxes, including those in damp and wet areas. The provisions of this paragraph do not apply to conductors which form an integral part of equipment such as motors, controllers, motor control centers and like equipment. This Section specifies the minimum requirements for the selection and installation of electrical equipment in locations subject to the effects of water or high humidity (damp situations), that shall be achieved to satisfy Part 1 of this Standard.
Read More+34 910 257 483
Calle de la Innovación 22, 28043 Madrid, Spain