ELECTRICAL PROTECTION SYSTEMS DEVICES AND UNITS

Can fire protection and low-voltage electrical systems share the same cable tray

Can fire protection and low-voltage electrical systems share the same cable tray

Sharing the same cable tray or conduit with data cables increases the risk of mechanical damage and impairs fire resistance. While all data cable is ran within cable tray, about 20% or so of the fire alarm cable is sharing the same tray. Power-Limited Fire Alarm (PLFA) circuits, which make up the majority of modern fire alarm systems, are generally permitted by the NEC to share a cable tray or raceway with communications circuits, provided certain conditions are met. Poor segregation, inadequate fire resistance, or unsuitable fixings can compromise both system performance and occupant safety. YY, SY and CY cables are made to various manufacturers specifications but not governed by any National, European or International standard, hence these are not currently recognized in BS 7671:2018, Regulation 133. 1 of BS 7671:2018 requires every item of equipment to comply with the appropriate.

Read More
Overload protection for home electrical distribution boxes

Overload protection for home electrical distribution boxes

The key protective devices —such as fuses, circuit breakers, relays, and surge protectors—that help ensure the safety, reliability, and efficiency of power distribution. Abstract: To protect personnel, equipment, and maintain continuity of service for an electrical system, protection or fault interrupting devices are required. Adequate system designs allow for the system to withstand and isolate faults while not causing additional damage and/or outages. The unsung hero preventing these disasters lives in your distribution box - overload and short-circuit protection.

Read More
Individual commissioning of relay protection devices

Individual commissioning of relay protection devices

This paper suggests a process for performing consistent and thorough commissioning tests through many sources: breaking out relay logic into schematic drawings; using SER, metering, and event reports from relays; simulating performance using end-to-end testing and lab. The testing and verification of relay protection devices can be divided into four groups: Type tests are needed to prove that a protection relay meets the claimed specification and follows all relevant standards. Abstract—Performing tests on individual relays is a common practice for relay engineers and technicians. With numerical protection relays commissioning and maintenance has become far less complicated as a result of the information provided by the devices as well as the integrated self-monitoring. This is why protection relays must undergo thorough tests throughout their entire lifecycle – from development and manufacturing to commissioning and regular maintenance.

Read More

Get In Touch

Connect With Us

📧

Email

[email protected]

📱

Spain (Sales & Engineering HQ)

+34 910 257 483

📍

Headquarters & Manufacturing

Calle de la Innovación 22, 28043 Madrid, Spain