DUCTILE IRON PIPES AND FITTINGS

Can air pipes be run inside cable trays

Can air pipes be run inside cable trays

Question 1: Can mechanical utility piping or tubing containing water or compressed air be installed in cable trays with electrical cables? Answer: No. Cable trays are a support system for electrical cables, power, signal, and communication and optical fiber cables. Section 318-4 Uses Not Permitted states that "Cable tray systems shall not be used in environmental air spaces except as permitted in Section 300-22 to support wiring methods recognized for use in such spaces. Is anyone aware of a code stating that it is acceptable, or unacceptable, to run air supply tubing inside a wireway along with 480VAC, 3-Phase wires? My concern is that the air tubing may contain moisture and if it were to break water could get on the wires. This would severely obstruct airflow, violate building regulations, and create an extreme fire hazard.

Read More
Specifications and models of threaded pipes for distribution boxes

Specifications and models of threaded pipes for distribution boxes

Internal and external diameters, areas, weights, volumes and number of threads for ANSI schedule 40 steel pipes. This catalog includes SS threaded pipe (EN 10255) and pipe fittings based on the EN 10241 piping standard, which are used in the transportation & distribution of liquid and gas. - Resources, Tools and Basic Information for Engineering and Design of Technical Applications! Deutsches Institut für Normung - DIN - pipe, tube and fittings standards and specifications. All the piping systems and equipment supplied under this package shall be designed to operate without replacement and with normal maintenance for a plant service life of 30 years, and shall withstand the operating parameter fluctuations and cycling which can be normally expected during this period. Pipe and fittings are Kite Marked to BS EN545, BS EN598 and ISO 2531 for water pipeline applications. The Plastics Pipe Institute (PPI) has prepared this Model Specification as a service to its members and the industry.

Read More
Vertical spacing requirements between cable trays and pipes

Vertical spacing requirements between cable trays and pipes

In general, vertical spacing for cable trays should be 30 cm (12 in), measured from the bottom of the upper tray to the top of the lower tray. The spacing between trays, whether horizontal or vertical, depends on various factors like cable type, environment, and tray material. Proper installation can significantly reduce electromagnetic interference, prevent fire hazards, and improve overall efficiency. Although BS 7671 touches on the subject of cable supports, it does not detail specifically what these support distances should be. The cable tray is installed in parallel with the general process pipe (such as compressed air pipe) not less than 400 mm.

Read More
Communication Four Corner Iron Towers

Communication Four Corner Iron Towers

The 4 legged angle steel tower, also known as a four-legged lattice tower or angle iron tower, is a type of structure commonly used in the construction of transmission lines, telecommunication towers, and other applications where height and stability are required. The aim of the project is to Design, supply, 120m high self-supporting four legged steel lattice communication tower including inner ladders, cable trays, inner &outer platforms, galvanizing, obstruction painting & obstruction lightning and accessories for mounting/installation UHF, HF, FM, Dish. These towers are constructed using interconnected steel angles or angle irons that form a lattice framework, creating a. This brought us to a diverse list of products ranging from a light duty tower, used in the two way communication market, to our four legged angle iron tower suitable for. A communication tower is a type of signal transmission tower, also known as a signal transmission tower or communication iron tower.

Read More

Get In Touch

Connect With Us

📧

Email

[email protected]

📱

Spain (Sales & Engineering HQ)

+34 910 257 483

📍

Headquarters & Manufacturing

Calle de la Innovación 22, 28043 Madrid, Spain